- 最后登录
- 2020-6-23
- 金钱
- 1057
- 注册时间
- 2015-7-10
- 阅读权限
- 50
- 帖子
- 454
- 精华
- 0
- 积分
- 739
研究生
|
: I saw his review and tried it but it didn't work. However, I discovered that you can easily reset these. You need to jump a wire from a point marked LED on the circuit board to a brass contact marked TEST and hold it for 5 seconds. Then jump again from the LED to the brass contact labeled RESET for another 5 seconds and BINGO!! If at first it doesn't' work try again. In fact, I have since then installed 2 momentary switches in my wifes Illumask so i can easily reset it whenever I want without having to open it. works amazingly!
What they say about LEDS is baloney. LEDs last at least 50,000 hours (200,000 applications) and the installed batteries are alkalines and they will last a long time. When they wear down just put in 4 new duracells and use the Illumask long after the 30 days go by. it should last for years if not abused. 在amazon看的 来自: iPhone客户端 |
|